Yet another 2'' Roxy rocking risers thread

[avc8130]

Anyone used the Rox anti-vibration risers, do they actually worth the additional $$$ ?
http://www.amazon.com/Rox-Speed-FX-Anti-Vibration-Handlebar/dp/B005UGHWL4/ref=cm_cr_pr_pb_t

Just to make sure, the stem clamp for the S10 is 1 1/8''?

No experience with the rubber, generally I don't like that stuff as it steals some of the road feel.

1 1/8" is correct.
ac

 

[Blaine]

If this was mentioned someplace, I'm sorry. ::002:: BUT, try moving the two throttle cables to the front side of the mirror stem....(I bought brake and clutch lines that were plenty long enough) My Roxies moved the bars an inch back and an inch up....I would like to move them back some more (I'm a stubbie little bastage : )

 

[jc450]

For those adding aftermarket bars the MSR bar end kit screws are too short. Easier just to go to the hardware store after you figure out what you need. To reuse the bar ends you need screws M8x80.

Regards, jc

 

[avc8130]

For those adding aftermarket bars the MSR bar end kit screws are too short. Easier just to go to the hardware store after you figure out what you need. To reuse the bar ends you need screws M8x80.

Regards, jc

Did 80 work? I think I used 100s, but there may have been extra thread.

ac

 

[swampyvt]

The MSR ends I got I ended up using M6x90

Sent from my XT907 using Tapatalk 2