Search results

And you CAN get the left side panel off pretty easy. Be careful when disconnecting the battery - the wrench will spark when it comes in contact with the crash bars. I found this out by experience.

WOW! Good run down on great adventures.

Yes - just found out Flash-2-Pass went bust. They should have the decency to put that on their phone recording and get rid of their website.

NICE!

I love the Altrider. They look great and you can remove the panels underneath easily. I would buy them from Revzilla.

Nice! & you SAVED 70 bucks!

Yes - you need a single T50 bit to put into a small socket to get though the upper hole. ...and the nut on the back is a bear to break loose without leverage - may need a bar to go over the wrench etc. I used a large adjustable wrench to make the 14mm long enough to break it loose. But some...

Also, the T50 Torx socket I had was too large. I had to use a single bit, and put that into a small socket to get through the upper hole.

AWESOME SHOTS!!!! Green with envy!

Prayers for you iClint! ...and thanks for sharing this information as a reminder to all of us to be careful out there. Boot talk - I can say from experience on the dirt bike (450s) that gear is a PIA, but it helps. It can SAVE YOUR ANKLES & FEET! Regular off-road boots are hard to shift...

Darn, I already boxed the old up. But I did see the side by side in another post somewhere - a very long post. This one does have the smoke colored sides and Tenere Logo. It also has some molding for rigidity toward the bottom.

Why is this yellow mark on every Tenere I've ever seen? Sent from my SM-G900V using Tapatalk

Why did you come out wth red as soon as I bought a blue one? Sent from my SM-G900V using Tapatalk

I just put one on my 2014 today. Love it. I'm 5' 10" 29" inseam. Every helmet may impact results but I will attempt to explain my results. Greatly reduced noise on 5he sides of my helmet. I no longer hunch down 2" to get out of the wind. At 70 MPH I can leave face shield up and it will no...

Late reply, but yes, after you install the plug n play factory gips, they are operated by the rocker menu sith on the left. Sent from my SM-G900V using Tapatalk

Giant Loop Zigzag Handlebar Bag part number 0872-0001020369 GL-ZHB. $55.00. Used my Revzilla bucks as it's overpriced. Sent from my SM-G900V using Tapatalk

I ended up with this one from Revzilla. Not waterproof, but a good place to put the cell phone & wallet without unlocking something. I like the fact it had tabs to use wire ties to allow full stretching of the zipper. Sent from my SM-G900V using Tapatalk

Sent from my SM-G900V using Tapatalk

One more pic to show the front contour. Sent from my SM-G900V using Tapatalk

...and love it. Sent from my SM-G900V using Tapatalk