Recent content by LarryI

  1. L

    Sold: Tall Touring windshield

    Hello , can i get the measurement from bottom to top? I am looking for taller screen than stock , but dont want a giant screen . For long road trips. shipping to 28617 ?
  2. L

    Barkbuster recommendations?

    one other thing i do on MX bikes put a pice of plastic from a pop bottle under teh clamp of a perch, this allows it to rotate on impacts . seems to work very well . Just bump with palm to put back to position.
  3. L

    Handlebar ergonomics

    My bars have a bend in them from a drop, I am looking at Renthal Gold fatbar # 819-50 . built for MT09. They are a bit narrower than original. In my MX adventures Pro Tapers bend easily , Renthal can take a drop or 2 before bending . The handguards will need to be adapted by bar end...
  4. L

    Hammock camping

    Can you give a review of this hammock tent ? now that you have had it for some time ? I am interested in a set up like this
  5. L

    Clacking from clutch area New sound

    Take up feels normal, good position, No excessive stiffness in the clutch pull ( Its hydraulic may not feel if there was ) pulls nicely thru power range, power loft front easily with 2 up riding , ( no slippage or loss there )
  6. L

    Clacking from clutch area New sound

    Teh bike is '15, Serviced valves, checked timing 3 times over , it is correct, Took apart tensioner twice to be sure it was releasing and adjusting . CHain pops tight when push on teh guide on tensioner during assembly However I dont know how to measure if it is run out of range. Codes ...
  7. L

    hard start / coil related ?

    unknown , purchased the bike last summer from a great guy in here . I will probably replace it this spring , just because I dont really trust it for longer trips which i plan to go on.
  8. L

    Clacking from clutch area New sound

    SO My bike started a clacking or knock in the clutch area of engine, I fully services it, Set valve lash. Tripple checked timing ! sound still there. Seems to go away a good bit if I pull the clutch lever in . I am going to tear down teh engine after Hollidays any advice what to look for ? I...
  9. L

    hard start / coil related ?

    Hello all, my issue occurs mostly after i ride to work, and restart in teh eve to go home. Cold mornings warm day sunshine then cloudy cold eve. My coils are rusty, OHM good new plugs greased properly. cleaned coils, I also have the issue after washing teh bike. With a jump box teh Bike...
  10. L

    Please Don't Shoot Me For These 2 Questions! [Flashing ECU]

    button on right hand controll lower slide switch , says " MODE " push it and watch teh dash at Mode bottom of display
  11. L

    New member from the Carolinas.

    Welcome from NC .
  12. L

    I'm looking for testers and opinions on Handguards Extensions (US)

    Hello, I am interested, I ride evenings in the mountains. I have lot of bug hits, small limbs sticks on backroads, and get caught in the rain alot. As well as looking for more wind protection . Its cold already in the mornings going to work . I dont like bulky gloves, thus the need for...
  13. L

    another hesitation and miss Q,

    Thank you sir, I have ohmed the coils and they are proper. I have Fluke Meter ( comm Tech) . I will try to figure out how to get a gage on the fuel line, as well as find the proper range of pressure. thanks for the thread Link .
  14. L

    another hesitation and miss Q,

    2015 Super Tenere , unsure about any wiring recalls,, only thing i know about a recall is what i have read in here pertaining to earlier models, .
  15. L

    another hesitation and miss Q,

    I bought the bike at 56,000mi. mostly cross country travels. one day i was riding , It started to hesitate backfire, just barley run at all. very difficult to get started, eventually got it home keeping high rpms. OK added water treatment for fuel. took apart. Findings : conciderable amount...
Top