Recent content by kdjbrown

I built a buzzer that it attached to the seat pan and vibrates when the turn signals are on. I also wired in an interrupt relay so when I apply either brake, the buzzer stops. It keeps it from being annoying while sitting at a long light. Works very well. Sent from my LG-H810 using Tapatalk

I have a Yoshimura R4. Install was simple and it sounds great. I agree with Groundhog, the soun is good without being loud. I keep the throttle In check until I leave my neighborhood so as not to annoy the neighbors, but when you twist the throttle on the open road, the bike bike sounds throaty...

I agree with La Knee. I had AC flash the ECU and mounted a Yoshimura slip on. She is quick, has plenty of character, will stand the front end up on command can pass in almost any condition without dropping a gear. I have no power complaints ar all. Currently have 3 bikes in the garage, but...

I would question the labor hours. I do my own oil changes and it takes less than 20 minutes. They charged 3 hours?

I have a Yoshimura. Sounds great but not too loud and does not affect license, fender or turn signal. Sent from my SAMSUNG-SGH-I337 using Tapatalk

Good thought, my 2nd gear snap did trip the TCS (thus governing front tire air time). Maybe that's OK for maiden run. Will give TCS Off it a try! Thanks again.

Flashed ECU arrived today from AC. By the time I got off of work and installed I only had time for a short ride. In a word, IMPRESSIVE! AC did himself well. Snappy and spirited, yet smooth and controllable. Example-"S" mode, 2nd gear, rolling 15 mph, snap the throttle open and without trying...

I'm sending my ECU off to AC to be reprogrammed. Have also ordered a Yoshi RS-4 slip on and K&N breather. Today she is factory shock and should have these mod installed and functional a couple of weeks. I'm in Florida and should be able to road test right away and let you all know the results...