CowboyJim said:
Hi, I plan to tap into my rear tail light wiring and posi taps seem to be a solid solution. My question is, what size taps do you need? AWG 14-16? Also, does anyone know where to buy them locally or are they mail order only. Thanks!
Sent from my SCH-I545 using Tapatalk
I will answer my own question. I purchased the 12-18 AWG grey positap connectors since I measured the OD of the wires and they appeared to be 18 AWG. The grey ones work fine. I suspect the red 18-24 AWG connecters will work too since there is overlap in sizes.
Also, here are the wiring taps you will need to make. There are already posts about tracing the cables so I won't repeat that:
Ground - Black (in brake light bundle or turn signal 2 wire bundles)
Brake light - Yellow (brake light bundle)
Tail running light - Bl/Rd - Blue-red dot (brake light bundle)
Left turn positive - Ch - chockolate
Right turn positive - DG - dark green
I used to posi taps and they work like a champ! Highly recommended. I had to buy off of eBay since no one carried them locally (Car Quest had posi lock connectors, but not posi taps). I hope this helps anyone else install strobes or a LED bar like I did.