The old fat dude abides too:
k
snakebitten said:Oh contrare. I'll follow that guy without worry.
Wish I was dodging his back tire mud-sling as I type.
Sent from my SM-N950U using Tapatalk
Got it. Customer pickup is at the Big Bob pavillon. LolSilverBullet said:I'll go inside right now and check for you.
Sent from my SM-G860P using Tapatalk
Thank you all for the help, got the plug. Also Romney was awesome in accommodating me. They pulled the plug off a new bike since they didn't have any in stock.SilverBullet said:Got it. Customer pickup is at the Big Bob pavillon. Lol
Sent from my SM-G860P using Tapatalk
I went down and the bike landed on a rock, Without the skid plate and crash bars the bike would have been totaled (frag'd engine and electronics). Should've had the weight to the rear and steering with the throttle. Took out the oil filler cap, bent the mounting tabs for the crash bars and the crash bar and dinged up the skid plate pretty good too. This is where Rumbux or a RideonADV skid would have likely fared better. This isn't the first time I've been down on that side, i'be gotten my moneys worth out of them.snakebitten said:Only broken shifters?
No broken heads or legs. Good job gents!
Sent from my SM-N950U using Tapatalk
Did the beer can shifter hold get you home?eterna1_drag0n said:Had my shifter break from a hiccup on a dirt road (a week weld on my chopped and extended lever) Folks at Romney offered to pull a part off a brand new 2018, talk about service! I couldn't justify the part cost though and decided to cobbled together my own solution of JB weld, rolled beer can, and a bit of wire. Thanks to everyone for the help and fun side commentary.
Worked great no issues at all. Going to pull it off and reweld it soon.SouthmtnJim said:Did the beer can shifter hold get you home?