SparrowHawkxx
Active Member
Yes, I was thinking maybe some Posi-Lock connectors.
Thanks for the pdf, I could not find links to any installation information form their home page.
I guess they don't want you to see this until you buy it then they give you a link to this info ???
So I did a search and found a link to an Installation Page.
This installation page has a short installation video and a link to the Manual
Another Manual I found - link
A couple of reviews:
MO Tested: Smart Turn System Self-Canceling Signals (October 28, 2016) - link
Smart Turn System Review (April 8, 2017) - link
Locating the connector that comes from the handlebar switch housing:
See picture below and another attached picture. The plug just above the battery, the female part is white and the male part is black.
I checked the wire colors in this connecter and confirmed that they matched the wiring diagram in the Factory Service Manual.
Right turn signal - Dark Green, Left turn signal - Chocolate, Turn signal/Hazard Relay - Brown/White
The white plug is the end of the cable that comes from the handlebar switch housing and is where you would cut the Chocolate, Dark Green, and Brown/White wires and then connect the ends of the cut wires to the STS.
This is a 10 pin connector. You can see the front row of five, from top to bottom: Dark Green, Yellow, blank space, Brown/White, and Red/Yellow.
The Chocolate wire is directly behind the Dark Green wire.
The blank space would be a White/Yellow wire for flash to pass switch if I had it on my bike.
Thanks for the pdf, I could not find links to any installation information form their home page.
I guess they don't want you to see this until you buy it then they give you a link to this info ???
So I did a search and found a link to an Installation Page.
This installation page has a short installation video and a link to the Manual
This is the manual that it links you to: STS_install_manual_ENv3.pdf - link
Notice the file name, it is a different version than what WJBertrand posted. I could only find minor differences though.
I would like to be able to navigate to the installation material from their home page so you might have some indication that you have the right version.
Another Manual I found - link
A couple of reviews:
MO Tested: Smart Turn System Self-Canceling Signals (October 28, 2016) - link
Smart Turn System Review (April 8, 2017) - link
Locating the connector that comes from the handlebar switch housing:
See picture below and another attached picture. The plug just above the battery, the female part is white and the male part is black.
I checked the wire colors in this connecter and confirmed that they matched the wiring diagram in the Factory Service Manual.
Right turn signal - Dark Green, Left turn signal - Chocolate, Turn signal/Hazard Relay - Brown/White
The white plug is the end of the cable that comes from the handlebar switch housing and is where you would cut the Chocolate, Dark Green, and Brown/White wires and then connect the ends of the cut wires to the STS.
This is a 10 pin connector. You can see the front row of five, from top to bottom: Dark Green, Yellow, blank space, Brown/White, and Red/Yellow.
The Chocolate wire is directly behind the Dark Green wire.
The blank space would be a White/Yellow wire for flash to pass switch if I had it on my bike.
Attachments
-
266 KB Views: 26
Last edited: