Longboard
New Member
Just wanted to give a heads up.
Today I pulled off my Hepco & Becker rock guard and installed my new Arrow header. When I went to put my rock guard back on I couldn't because something was hitting it. After looking around I found that one of springs that attaches the front pipe to the mid pipe was hitting the guard. I thought about it and dicided to open a hole up in the gaurd giving room for the spring to pop through. This allowd the gaurd to go on with out any problem.
I was also a little concerned about the front O2. It wasn't hitting the guard but was close. So I notched a little openeoing just in case.
Today I pulled off my Hepco & Becker rock guard and installed my new Arrow header. When I went to put my rock guard back on I couldn't because something was hitting it. After looking around I found that one of springs that attaches the front pipe to the mid pipe was hitting the guard. I thought about it and dicided to open a hole up in the gaurd giving room for the spring to pop through. This allowd the gaurd to go on with out any problem.
I was also a little concerned about the front O2. It wasn't hitting the guard but was close. So I notched a little openeoing just in case.