Arrow header + Hepco & Becker heads up.

[Longboard]

Just wanted to give a heads up.

Today I pulled off my Hepco & Becker rock guard and installed my new Arrow header. When I went to put my rock guard back on I couldn't because something was hitting it. After looking around I found that one of springs that attaches the front pipe to the mid pipe was hitting the guard. I thought about it and dicided to open a hole up in the gaurd giving room for the spring to pop through. This allowd the gaurd to go on with out any problem.

I was also a little concerned about the front O2. It wasn't hitting the guard but was close. So I notched a little openeoing just in case.

 

[~TABASCO~]

That cut out looks good !

 

[Longboard]

Drill, dremal and some good old hand filing ::008::

I got my PCV and auto tune all wired up this afternoon and everything seems perfect. Tommorw I'm going to load your map on and then ::26::

Longboard

 

[~TABASCO~]

I tried to send you a map but the email got kicked back?

 

[Longboard]

I will call you tomorrow.

LB

 

[sportrider]

My Wasp carbon exhaust touched my H&B bag mount. The pipe was an inch too long so I had to add spacers to move it off the mount and add a spacer to the heat sheild.

 

[3putt]

Nice job. I have a H&B, thanks for the heads up.

 

[Kevs]

This was a case when one of our Sgp's rider mounted the H&B skid plate with Arrow headers.

He too did the same by cutting an access for the spring to be from preventing the plate to be mounted.

Nice job on the O2 sensor, will consider mine too..