Britt
New Member
Not sure if this will be helpful to anyone out there, but I've been looking at ways to increase my visibility on my recently purchased Tenere while out in traffic. I looked at several options and decided on the Admore light bar which is a "LED High-Powered SMT Light Bar with modulating brake light, progressive, amber turn signals and new Smart Brake technology". https://www.admorelighting.com/product/admore-smt-light-bar-with-smart-brake-technology-new/
I installed the original version on a friend's NC700X and liked it a lot. This is the improved version with programmable firmware as well as a deceleration sensor that illuminates the brake light when engine braking.
Rather than putting it on the license plate as designed, I decided to put it up high - at eye level with most car drivers. I bolted it to the top case and connected it to the bike using a 5 pin trailer connector to connect the 5 wires from the device to the OEM wiring.
Very happy with the outcome. It's super bright and will hopefully grab the attention of most drivers!
Video showing hazard flashers: https://www.youtube.com/watch?v=nEuBV8zT8yw
I installed the original version on a friend's NC700X and liked it a lot. This is the improved version with programmable firmware as well as a deceleration sensor that illuminates the brake light when engine braking.
Rather than putting it on the license plate as designed, I decided to put it up high - at eye level with most car drivers. I bolted it to the top case and connected it to the bike using a 5 pin trailer connector to connect the 5 wires from the device to the OEM wiring.
Very happy with the outcome. It's super bright and will hopefully grab the attention of most drivers!
Video showing hazard flashers: https://www.youtube.com/watch?v=nEuBV8zT8yw