Search results

Rostra cruise control kit contents I probably missed this some where but looking on Amazon dot com I see the Rostra 250-1223 but it looks like the control switch is a separately sold item while in your picture of the parts of the kit, it appears to be part of the kit. (your picture at...

Just a short update. I ordered my horns at the same time I put the last update on. I got one of them fairly quickly and I've been waiting on the other one for all this time. I still don't have it. Amazon is usually quick in shipping but not this time. More when I get my other horn.

When you have the brake lines off and ready to replace them with the new ones, couldn't you just replace the bleed screw with the speed bleeder at that time and do the same process, tapping the brake line, etc? Or is that too deep into the system to keep air out of the abs??

I haven't seen this discussed yet. I have the long lines with the bleeding instructions and am ready to install them. My question is: Is it possible, when you replace the lines to also install "speed bleeders"? The only instruction with the long lines is for bleeding the lines. Nothing...

Well, I finally found them. They are easily accessible just not visible until you move the other cables out of the way. Both the aux lights and the grip heater plugs are right beside the tool pouch. I'm waiting on my horns before I continue on with the installation. I'm going to end up...

I was worried about that so thanks for the "kick in the pants" I needed to look at the wiring diagram. It "appears" to me as if there are only two circuits/relays that are NOT powered until the ecu turns them on. I'm "assuming" (again a risk) that the ecu does not turn them on until the...

Wow! Was that quick. Now you are saying that either of those two wires have no power when you turn the bike on and don't have power on them until the bike is started and running? It would make sense (unlike some other bikes :)) that you wouldn't want power on the heated grips until after...

I believe I have seen this either on the S10 forum on adv.com but I cannot find it now. But I may be thinking about an entirely different bike so I need help. Is there some where near the battery that I can pick up +12V to switch a relay but only available when the engine is actually...

PM sent asking for one 3 pin and one 4 pin. Need paypal address and exact amount required. Not clear now if $10 per connector or total, due to later posts. thanks, Missouri Harry

I also want them but it seems I'm not fast enough. Missouri Harry

Is this still for sale? Do I understand correctly that the purpose of this is to give the ability to add heated grips to the XT? thanks, Missouri Harry

Sorry to hear about the obstacle placed in the way of your riding a Tenere but hang in there and hopefully it will eventually turn around. Foot still available? If so, what are you looking to get for it? Missouri Harry

Re: First North American SupaT gathering - Yukon Canada 2012 Out of curiosity, what would you say the "level of difficulty" of this ride would be? Say a 1 is a typical gravel road in the U.S. and 10 would be the Iditarod Trail in the summer??

Re: First North American SupaT gathering - Yukon Canada 2012 AMEN brother ::026::

Now THAT sounds interesting. I think I'll pencil that in. After I found my Tenere (picking it up next weekend) I started thinking about doing the Key West to Prudhoe Bay run. Now, on the way back, I could stop in Whitehorse. That wouldn't be as bad for you, as all you would have to do is...

Re: First North American SupaT gathering - Yukon Canada 2012 The riders that would go to this would be the "committed" ones. Or maybe it's the "should be committed" ones. I'm putting it in my calendar because as soon as I found my Tenere (pick it up a week from next Saturday) I started...

Re: First North American Super Tenere gathering - Whitehorse,Yukon Canada July 2012 I'm putting this in my calendar.

I had previously thought about doing the Key West to Prudhoe Bay run before I heard about a Tenere. Now I'm thinking harder about it. But I like to stop and smell the roses once in a while and that schedule doesn't seem to allow for a lot of that. I wouldn't think anything set up for IBA...

WELL ::016:: ::020:: Things are REALLY looking up. I spoke to Tony, gave him some plastic to try melting and I'm now scheduled to pick up my S10 on the 24th. Thanks to all who helped me in my search for the gem of the East SSSSSUUUUUPPPPPEEEERRR TTTTEEEENNNNEEEERRRREEEE The adventure...

You would think so but I was in Anchorage when my GS started to act up and I had to change my fuel filter that had less than 20k miles on it. I guess the point is that you just don't know when/where sh*t happens. You just know it happens. If you're going to stay in the lower 48, you...