Search results

Hey everyone, Sold my 2012 Super Tenere last week and no longer have a need for the Akrapovic exhaust. Also included is a genuine carbon fibre cover that replaces the ugly Yamaha unit. The exhaust is in great shape and sounds terrific. $600 CDN is my price for both items. Purchaser to pay...

Just wondering what fuse (circuit) the horn receives current? I pulled my forks yesterday to grease and check my steering stem bearings. Put everything back together. Used my horn today and it gave a very quick and faint blast and now no longer works. I thought I blew a fuse but after...

Looking to buy both the upper and lower right side panels for a 2012 Raven Super Tenere as per the attached image. Looking for something is good condition and not beat on. Let me know what you have...

I headed into the garage today to perform some annual maintenance on the Tenere. I was surprised to find that both of my right side panels are broken where the upper and lower panels fasten together. The plastic on the lower cover appears to have become very very brittle. Almost like plastic...

Hey there, Digging around underneath my gas tank today doing some maintenance. Pulled the throttle bodies up and out of the way to install a new thermostat. Some time later I look on the floor and find this little guy. Some sort of a cap. I’ve looked around but no luck finding where it...

Looking for two pairs (enough for two cases) of the Touratech mounting pucks so I can fit a pair of Pelicans to a Touratech rack. I have a mailing address in both Canada and the US.

Anyone have a 2014+ CCT that they bought and maybe didn't install prior to selling/trading their Tenere? If so, I would like to purchase. I have a mailing address in both the US and Canada...

Hey there, I’m looking to order up some misc parts for the Tenere in preparation of my valve check this upcoming fall. Also looking for a new updated CCT as the rattle during startup seems more prevalent in my 2012 factory piece. Does anyone have an online source within Canada or a US source...

Hey guys, I did a quick search on my phone without much luck... I’m departing for a trip tomorrow and just changed out my rear tire. Unfortunately the rear valve stem is dry rotted a bit and leaking. Can anyone quote the type (ie: TR412?) of valve stem I need to replace the one currently...

Hey everyone, Dropping my 2012 off tomorrow morning for the ECU wiring harness recall. Just wondering what to expect and what to look for when I get it back? Does the tank need to be raised for this procedure or just removal of the right side panel?

Wondering when one should think about repacking the S10 Akrapovic muffler? I estimate there is approximately 25,000 miles on mine now (I purchased a used unit). Thanks...

Hey there, My 2012 rolled 31,000 kms (~20K miles) before putting it away for the winter season. I purchased this bike new in 2014 and usually take it on one or two trips per year where i find myself thousands of kms from home. I currently have some time this winter to focus on some...

Hey there, I have a 2012 Tenere and really haven't messed with many suspension settings since taking possession if it. A few weeks back I was on a multi week, several thousand km trip and noticed the front of the bike felt really loose at slower speeds (parking lot maneuvers, etc). I weigh in...

I'm currently on day 4 of an 11 day trip (many many miles from home) so any advice would be appreciated. Last week I performed a drain and fill of the cooling system with Yamacool. I performed the drain/fill as per the Yamaha FSM, started the bike and left the rad cap off for awhile to escape...

Looking for a set for my 2012. Thanks all...

Went to the local Honda dealer last week and ordered some Honda Moly 60 Paste as I was installing a new tire this morning and wanted to lube the drive splines. According to the local dealer, Honda Moly 60 is no longer available, and has been superseded by Honda Moly 77 Grease - which was...

I'm looking to purchase a SW Motech / Bags Connection EVO tank ring lock tankbag. I like the rigidity of these bags and the mounting method that minimizes scratches in the painted surface of the tank. I'm considering three different bags: - The Daypack - The Engage - The City I plan to use...

Looking to buy a lightly used rear exhaust cover in black. Thanks

Does anyone else have the front of the seat damaging the paint on their fuel tank? I only have ~ 4000 kms on my Tenere yet but notice the paint being rubbed from the front of the seat already. Has anyone come up with an effective way to combat this?

For those that spoon their own tires, how durable is the finish on the Tenere wheels? I have a new pair of TKC80's on the way and am wondering if I should install myself or take my wheels to a shop? Is the finish durable enough for levers or are rim protectors necessary? Thoughts?