Thank you for your time and dedication to this site. It's a lot of work and you've done more than your time! And you've done a great job with it.
Safe roads!
Liz
You guys are the best! Thanks so much for your well wishes and positive energy. I am indeed on a detour to my original plans to travel to South America. My shoulder is badly broken but well on the way to healing. I'm heading for my first post-op appointment this morning. Have been well looked...
Hey Dale - it was great to meet you at the Adventure Moto Rendezvous and Ride. Hope you had a safe journey back. This is my last week on the road. For now. :)
That may have contributed. Lifted the gas tank and disconnected, re-aligned the hose. Still wouldn't start until letting it sit for an hour. It's going now - hopefully stays that way.
Thanks!
Liz
So the valve clearances are fine.
Have put in new spark plugs, new air filter. Thought all the connections, hoses, throttle bodies, gas lines all went together as they should. No nuts and bolts left over.
But it won't start. Almost catches but stops just short of that.
Have read the thread...
This won't be exciting for most of you but it is for me! :) After much searching, found a valve cover gasket online - the last one in stock - had to have it shipped to a US address (OEM Rules). I picked it up on July 1st and got just about everything back together this morning (with help)...
Thanks everyone for your tips! Much appreciated.
Now I've just got to get the gasket which should be arriving today at a US PO Box. A delight to look forward to going across the Niagara Falls border on a holiday weekend in both countries! :)
I know this is a probably a no-brainer, so please bear with me. :)
When I took the valve cover off (and wrecked the gasket) - it didn't appear that there was any sealer on the gasket. The manual specifies 2 different sealer options.
Is sealer necessary and if so, does it matter which one...