Here is the windscreen / GPS mount I built this winter.
First I made a templet.
From the templet I made the (two) brackets.
After the brackets were made (and powder coated) I clamped it to the bike (using a 3/8” bolt as a locator) and drilled the mounting holes.
Mounting hardware and the 3/8” locating bolt.
Right side mounted.
Left side mounted.
In the hole on very the top of the mount I’ll put a cross bar that will hold my GPS. End result is I have a dual purpose bike with a dual purpose bracket. It stiffens the wind screen mount and holds my GPS.
Because of my metal inventory, and my contacts, my cost on this project was $00.00.
First I made a templet.
From the templet I made the (two) brackets.
After the brackets were made (and powder coated) I clamped it to the bike (using a 3/8” bolt as a locator) and drilled the mounting holes.
Mounting hardware and the 3/8” locating bolt.
Right side mounted.
Left side mounted.
In the hole on very the top of the mount I’ll put a cross bar that will hold my GPS. End result is I have a dual purpose bike with a dual purpose bracket. It stiffens the wind screen mount and holds my GPS.
Because of my metal inventory, and my contacts, my cost on this project was $00.00.