Rox Anti Vibe risers.

[Red dust]

I did order the anti vibe Rox risers for my ST but got wrong ones, 7/8 pivot instead of 1 1/8.
Since I did order from USA the shipping is quite expensive so I`m not sure if it is worth sending back.
Thinking about using the inserts that followed for 7/8 bars and make it to fit in the stock clamp area around the pivot will need to take off the pins though that is on the inserts.
Should work?
My other alternative is to sell them and get the right ones.

 

[mcbrien]

Or you could make a split tube 7/8 id x 1 1/8 od to use as a sleeve . ::008::

 

[Mikeybikey57]

Had the same issue with my Rox Risers, although I bought mine from an ex GS rider on e-bay. Did almost exactly the same as mcbrien has suggested but using some 3mm aluminium sheet that I formed into an open ended ring.

 

[Red dust]

It seems like you use the 7/8 handle bars, I got the Flexx 1 1/8 thickness so technically I could use the inserts for the smaller diameter bar from the Rox clamps to the pivot in the stock clamps

 

[mcbrien]

I like mine .

 

[Red dust]

You starting to think 147 at bats, 147 misses in a row on the vibe issue is beginning to look grim?
Sorry for all you've gone through without any luck. Risers aren't going to do anything except foul up the bar position, then you've got goofyball bars and vibration both.

I think the bar position will be great and with a new clutch basket the vibes might improve. I did not buy these risers mainly to get rid of the vibes but when buying risers why not get these ones, surely the vibes would not be more?