PUIG Windshield Install

[TheWrightStuff_KC]

I just got finished installing a new Puig Windshield on the S10 and figured I'd share my thoughts. Screen cost about $140 from Revzilla. I originally ordered the light smoke but FedEx squashed it. Since it was the last one that Revzilla had I went with the dark smoke. Screen quality is very good. Installation is simple as long as you have at least one hand and a philips screwdriver. Finished in about 5 minutes. Screen is about 3 inches taller and 2 inches wider. The dark smoke is quite a change. It really makes me feel like I'm looking "over" the screen. I'm about 5'10" and installed the screen in the high position. I have the seat in the low position. I still get a bit of noise coming off the top of the helmet. Once I get some more miles with it I'll send an update.

 

[Dant3]

Looks nice. Have you riden it yet? How are the impressions on the road?

Could you add a side photo od the bike so we can see the side profile of the screen (curvature, etc).

 

[TheWrightStuff_KC]

Hey guys. The Puig lasted a few weeks on the bike and then I replaced it with a National Cycle V-Stream Sport Touring shield. The new shield is much better. The Puig just wasn't tall enough for me. I also did not like the dark tint. I've added a profile photo of the Puig. I will be writing up a review for the V-Stream soon.

 

[Tremor38]

Hey guys. The Puig lasted a few weeks on the bike and then I replaced it with a National Cycle V-Stream Sport Touring shield. The new shield is much better. The Puig just wasn't tall enough for me. I also did not like the dark tint. I've added a profile photo of the Puig. I will be writing up a review for the V-Stream soon.

I'm considering the Vstream Sport Touring. You wrote you are 5'10". What is your inseam?

Sent from my SC-03E using Tapatalk 2

 

[TheWrightStuff_KC]

Inseam is 32."