Mastec crash bars

[Tenerefeller]

So I ordered the mastec bars from pak- meister and after a month long backorder they arrived and like another post mentioned were scratched though the powder coat badly in a couple spots, I was anxious to put them on so I sanded the spots down and primed them then got to fitting them on the bike. The welds are good looking, they are a little rough on the fit but went on easy enough for what they cost I am happy with the fit and finish other than the shipping damage.

/07/e78c622369fa86d4ca122dfa4ea1acdd.jpg[/IMG]

I will say that pak - meister is a great outfit to deal with and stayed in contact very well throughout the backorder process, and I will definitely be purchasing from them again!

 

[PowersUSA]

Were you able to mount them with both the plastic end caps in place? Mine would not so I ended up filling the ends with silicone. I repainted mine with Rust-Oleum Truck Bed Coating. Which reminds me I need to post pictures of the finished product.

 

[Tenerefeller]

Mine mounted fine, though it took adjusting them a couple of times and the instructions suck

 

[Tenerefeller]

 

[KPK]

Those do look good on the Tenere and I have been thinking of grabbing a set cause they are a bargain. Have either of you layed the bike over to test them yet?

 

[Tenerefeller]

Not yet, hopefully assuming I do my job right I won't need em! But once my back is back in (I threw it out an hour after) I'll get a shot of the angles