So the instruction from the other threat read as followsTo install the Gear Position Indicator GiPRO-X (aka GPX) do the following:
1) follow the steps above, EXCEPT you DO NOT CUT the BLUE wire. The WHITE lead from the GPX is simply tapped into the BLUE wire using the supplied POSI-LOC tap connector.
2) The Black/Green (RPM signal) lead from the GPX is tapped into to the GRAY wire on the same ECU connector using the supplied POSI-LOC tap connector.
Problem is all wire have either stripes or dashes on them there are no solid wires.....And all the grey wires on the left connector have stripes on them....and of course all the pictures are no longer avaiable....
HELP
thanks
Dan
1) follow the steps above, EXCEPT you DO NOT CUT the BLUE wire. The WHITE lead from the GPX is simply tapped into the BLUE wire using the supplied POSI-LOC tap connector.
2) The Black/Green (RPM signal) lead from the GPX is tapped into to the GRAY wire on the same ECU connector using the supplied POSI-LOC tap connector.
Problem is all wire have either stripes or dashes on them there are no solid wires.....And all the grey wires on the left connector have stripes on them....and of course all the pictures are no longer avaiable....
HELP
thanks
Dan