sblissner
New Member
The purpose of this thread is to gage interest in top and bottom spacers to facilitate increasing the spring rate on ES models.
I would be having a local machine shop make a lower spacer per Karl's drawing and an upper spacer similar to the Racetech piece, shown by Super08 earlier in this thread, to take up the space between the upper body and the spring i.d..
Don't have a price yet, I'm sure it will depend on interest and my ability to spread any setup cost over more pieces.
If your would be interested post a reply in this thread. If there is enough interest then I will take drawings in and get a price.
Personally, $100 for the set won't dissuade me. It needs to be done in my case as I weight 240 and travel with full camping gear.
I would be having a local machine shop make a lower spacer per Karl's drawing and an upper spacer similar to the Racetech piece, shown by Super08 earlier in this thread, to take up the space between the upper body and the spring i.d..
Don't have a price yet, I'm sure it will depend on interest and my ability to spread any setup cost over more pieces.
If your would be interested post a reply in this thread. If there is enough interest then I will take drawings in and get a price.
Personally, $100 for the set won't dissuade me. It needs to be done in my case as I weight 240 and travel with full camping gear.