Can anyone with the factory piaa light kit take a measurment for me?

gunslinger_006

Well-Known Member
Joined
May 21, 2016
Messages
297
Location
Seattle, Washington
Hello

If you have the piaa light kit that yamaha sells with the lights below the main headlights: Could you put the bike on the centerstand and measure the distance from top of the fender to the bottom of the lights?

Thanks very much. Trying to check a clearance issue with a different light bar.

My bar measures 6.75” from the bottom of the bar to the fender with the ruler aligned to the fork.

I think with 7.5” of travel, if i bottom out completely, my fender may hit the light...but i tested this setup over a bunch of speed bumps and it doesnt hit. Feels like for the riding i do, its safe. Hoping to hear the factory kit measures about the same.
 
Last edited:

MIKE R

Active Member
Joined
Feb 5, 2012
Messages
470
Location
Lancashire, UK
According to my measurements the distance from the bottom of the lights to the top of the front mudguard is 6.5 inches (the silver tape holder is 2 inches)

I hope this helps

Mike
 

Attachments

gunslinger_006

Well-Known Member
Joined
May 21, 2016
Messages
297
Location
Seattle, Washington
According to my measurements the distance from the bottom of the lights to the top of the front mudguard is 6.5 inches (the silver tape holder is 2 inches)

I hope this helps

Mike
Thank you very much, Mike!!!

This is what i was hoping to see, that my kit is as high or higher than the factory. Awesome.
 
Top