I know everyone is dying of suspense on my tire update, so here it is! O
So I picked up the DynoPlug today from my local Cycle Gear and gave it a go this evening on plugging the tire.
This tool might not be the best for anyone with a bad shoulder or anyone without decent upper body strength... Man oh man was it hard to push the tool through the tire, as you can see from the pictures below the nail was pretty small. My kit came with a "worm" already loaded in the DynoPlug. I pushed it through the tire and when I yanked it out air was still coming out. Basically the worm was stuck inside of the tool so it ripped the pointy end off inside the tire and the worm was left in the tool. So after getting it out and loading another one I attempted it again. Second time the tool does not go in any easier than the first lol This time the worm stayed in the tire like it was supposed too.
So all in all very happy with the tool and my first successful tire repair. Although now I have a little pointy thing floating around inside my tire.... Doubt it will cause any problems, hopefully... But if you buy one of these kits I would recommend pulling out the one that comes pre installed just to make sure its not stuck.
Thanks again for all the noobie help ::012::