These aren't exact, but it is certainly an improvement over stock. I used nice round numbers and a stock drill size so if one was feeling froggy, and maybe a couple beers deep, this could be done with a vice, a drill, Dremel, and some spray paint. If you have access to CNC than it would be a piece of cake to match perfectly. Ensure your printer is set up to print 100%, print, cut out, and use as a template. It is an ADV bike, not a prom dress. If you end up going for it, post some pictures.
I just took the entire rear frame off, figure might as well send that out to get coated as well. Can't figure out why YAMAHA spec'ed it grey. The new ones overseas are black. Also found out that Germany is selling the WORLDCROSSER guards for the swingarm bits. Trying to get some here, but not having any luck. May have to make them, probably less than shipping a set to the USA, but those will take some trial and error. If I break the code on the sizing, will probably burn a bunch off to at least break even on the project.
I'm new to the forum and some may ask why I am spending so much time farting around instead of riding, well the short answer is I got sick in January, and I can't drive until the DR clears me in June....so may as well fart around with the bike.
Enjoy.