Search results

I have no speedometer or odometer and error code 42. I replaced the rear speed sensor but have not deleted the code yet. Anybody else lose their speedo/odo?

I know the gen 2 bikes have a reset button on the left side of the dash. The Gen 1 bikes have two buttons on the lower right side of the dash. But.. I can not find any info on how to delete fault codes for the Gen 1. Specifically 42 and 69 which are whee

Anybody had to replace the ABS brain? Approx cost?

Riding along almost home after a very spirited ride and all of a sudden I got two lights on and no Speedo. ABS light, oil light , 0 on the speedo and odometer not changed after 2-3 miles. I had the ECU flashed and wiring harness warranty work 400 miles ago. Coincidence?

I’m looking for a right side (non-exhaust) OEM hardcase. I have nearly new top case to trade or purchase right side only. Not looking for perfect condition or color.

Just wondering if anyone has replaced their oil pan due to damage or for any other reason. Was it easy? PITA? I have JB welded mine more than once after a bad pothole at high speed so it's time to replace it. The aluminum pickup needs replacing too. That part is easy, but not sure if the whole...

As per the low ground clearance on these bike I hit a deep pothole at a high rate of speed and ended up riding the front tire only for a short distance. Bent the skid plate , steel bracket for the skid plate, oil pan and the aluminum "pick up" at the base of the pan. I have been getting by with...

Just installed a new battery AND a light bar. The dash is all good except my clock/time. How do I reset it? I have a complete workshop manual but can not seem to locate the instructions.

Does anybody live close to Trinidad Colorado? A few of us are planning to ride the TAT, trans America trail ,beginning in Trinidad. Looking for a safe place to park a truck for about a week. Aug 22-29 ish. Thanks

Anybody installed a Scotts damper?

ust moved to a new house and can't find my manual. Anybody know the torque specs for a 2012 front fork upper and lower torque specs? Dropping my tubes, thx.

Looking for undamaged parts from a dead donor bike. Oil pan and front brake rotors from a 2012. Let it be known that I have not crashed my own bike, but rather have ridden off road enough to have cracked the oil pan WITH a skid plate and bent a brake rotor while contacting a large dog on a dirt...

I bought my bike used and it came with a 2.5 inch length oil filter. Are there shorter one avail? Is stock filter 2 inches long? Fitting skid plate issues.

Has anybody had luck using the Alt rider crash bars AND the OEM Yamaha lower bars together? They use the same mounting holes but Altrider bars go inside the bolts and OEM goes outside the holes so I'm hoping a longer bolt and a little bit of fabrication I can make both of these work together...