Search results

I have ran the Aerostitch Grip Wraps a little bit now and they seem to work well. They are a good cheap alternative to try out heated grips before making a more permenant investment…. and they can transfer over to another bike easily. However …. I have found that with my relatively short...

I sure wouldn't be sitting around with a big grin on my face if I just did that to my bike?

My harness was swapped out today.....we'll see if this one fairs any better.

Don't post a pic of that connector without providing a P/N or source.... ;D

ATV Mid matches rise with less sweep .....

Oem side deflectors, stock shield with Madstad = ::012::

An audible hum ... normal..... a squeal is not.

Hopefully they aren't adding a beak!

Yes, the bulb was burned.... My dealer replaced the bulb after inspecting the discolored wiring and the new bulb does work. I received notice that new harnesses are back ordered until mid Dec as well.

That would be just the 39 that bother to follow/comment on this forum..... ::013::

IMO this is more of a pure heat issue off the bulb .... I removed the plastic connectors completely last year and at the same time re-crimped the connectors so that I had to work the connectors onto the bulb spades. Wires looked pretty good at that time, but now they are pretty well cooked (Both...

........ ::008:: Agreed ... I would much prefer to have all front illumination in working order!

Idaho ...........

I paid my dealer a visit today to show them what I found upon removing the cap.... they did agree that upon visual inspection something did not look right. They are contacting Yamaha regarding the issue and I have full confidence that my harness will be replaced. They claimed to not be aware of...

Looks like I might be the next with harness issues.... found my right side bulb not working this afternoon... popped the cap and found some pretty discolored wires... notice no Blue/Brown .... more like a very faint Lt Blue/White. There is also a white coating on the inside of the cap. The...

How about the Trail Stand?

I went with a Pro-Taper ATV Mid, similiar rise with half the sweep. I have also since added a Tusk 5/8 riser .....

Uh no, not really.... but to your point the statement was more that "I doubt he is a bad rider". I also surely doubt any one commenting on this subject has ever over cooked a corner, missed the apex, etc, etc. ::002::

IMO images 6-8 confirm plate contact... Also noticed how much higher his footpegs appear to be in relation to the bottom of the slid plate. I doubt the rider is at any fault here.... the frame work of the skid plate, which is neccessary for the type of protection this system provides...

My vote is that you have a seal failure either in the master or the caliper.... take it in and get it fixed.