Recent content by Vasos

no , the screw on the kit is 8mm the hole in subframe 12mm, something is wrong … i will call and GIVI and KAPPA tomorrow and solve the mystery, also because subframe bore is 12mm you have to use 12mm screw....so there is no chance to pass a 12mm screw threw supports no V785R cause there hole...

this is the kit i have but it says is for 13-14 models ,mine is 2020 model ,one month old , and both GIVI & KAPPA give this one ,and it does not fit so most probably its there mistake,the distance between holes is 12mm bigger on subframe, also where it fits on rear peg there is 4 cm distance ...

i think has nothing to do with handles ,its the distance between holes

hi there i took kappa cases together with PLR2119 for 1200 2020 model and dont fit , distances of screws on subframe wrong ,support on co driver peg wrong ,please advise

hi again , i received my cases and supports KLR2119 and they dont fit ! distance between screws on subframe its different and support for co driver peg does not fit , any ideas ?

ok , so instead of waiting for delivery, as you suggest i could 'make' them, do you have any dimension / length of this spaces to finish with story

correct i am in Europe (Cyprus actually) i am 99% that you are correct , we see tomorrow ,i hope everything ok, thanks a lot for the answer and all the efforts ... thanks

hi everybody hope you all doing well , tomorrow i am about to receive my side cases together with the KLR2119 SUPPORTS for quick release ,looking at the installation instructions i start wondering if they will fit cause on my 2020 bike there is no metal passenger holder ... and it looks like i...

if we eliminate clutch sensor ? whats the effects ? probably will not start ,check engine light, cruise control wont work ...

thanks a lot , issue is that is not ergonomic for driver .

i am not sure if i understand :)

Hi everybody i am new here , i just got a brand new Super 1200Z 2020 model , my questions is about the clutch and gear indicator , as you know pulling the clutch the gear indicator shows no number ... i did not understand whats the logic behind it and actually i find it more useful if continue...