bmrdude62
New Member
Got my Denali lights installed, power/ground hooked up, but need to know where to tap into a "hot" line for the switch. Any suggestions appreciated!
Where to tap into a "hot" line for Denali Lights switch?
- Thread starter bmrdude62
- Start date
For which function, to run a relay slaved to your high beam? Or to run a relay to switched power source?
For high beam, you can tap into the wire under the left handle bar.
For switched power, use the cigarette lighter wire. I just did one for somebody else and tapped in where it is behind the upper right side panel. I by memory it is black with a brown tracer.
For high beam, you can tap into the wire under the left handle bar.
For switched power, use the cigarette lighter wire. I just did one for somebody else and tapped in where it is behind the upper right side panel. I by memory it is black with a brown tracer.
fred-houston
Member
Below is where I tapped in for switched power to the relay to my driving lights. The tag states it is for my fuse block, and it is, it is the switched power for the relay to my fuse box where I power the lights. If you are not using a fuse block, then the same source can be used for switch power to the relay to your lights, though I would install a fuse if going that route.
bmrdude62
New Member
Got it! Thanks guys ::014::