roger123
Member
Checked the valves on my '14 Tenere ES and now it won't start, getting fault code 060 (YCC-T drive system, malfunction detected).
From the service manual pg 8-69, TS guide:
1. Throttle servo connector is connected and I get power to one of the pins with the key on so it's getting power to the motor.
2. I never disconnected the ECU so I'm pretty sure no issues there.
3. Fuse is good. Also verified power to the fuse (as well as to the connector to the servo).
4. I guess I need to check continuity here next but my wires don't seem to be this color.
I even disconnected the battery for an hour or so to see if it would clear, no joy.
Just tossing this out there to see if anyone's had this issue. Sucks that I turned my bike into a ginormous paper weight(
From the service manual pg 8-69, TS guide:
1. Throttle servo connector is connected and I get power to one of the pins with the key on so it's getting power to the motor.
2. I never disconnected the ECU so I'm pretty sure no issues there.
3. Fuse is good. Also verified power to the fuse (as well as to the connector to the servo).
4. I guess I need to check continuity here next but my wires don't seem to be this color.
I even disconnected the battery for an hour or so to see if it would clear, no joy.
Just tossing this out there to see if anyone's had this issue. Sucks that I turned my bike into a ginormous paper weight(