Search results

Hi Chaps What are good engine bars for my gen I S10 which are available in the UK? I have a Yamaha engine guard and the World Crosser guards too. I obviously don't want to start cutting stuff to make it fit. I have included a big picture so you can see what I mean. Cheers

Whilst having the airbox out to replace the ignition , I thought I'd check the plugs only to find the fist coil M6 bolt having about an inch of blue thread lock on it. It was a but of a mission to get out due to the restricted access above the bolt heads. I will clean the threads and put some...

After the faff of removing the rear wheel for the first time to change the tyre and refitting it ( using the method posted on here) which also had the extra 'World crosser' guards to contend with. I went to change the front. (after waiting 24hrs for a 19mm hex 1/2 drive socket to arrive in the...

Hi Chaps I have a replacement ignition to fit. I did try a search or 2 without any luck so here is my question. What is the best way to remove the two security bolts holding on the ignition? I thought of removing the top yoke and use an Irwin bolt remover on a rattle gun . But I thought I'd...

Hello Sorry to post this here but I didn't know where to post this question. I have just bought a cheap S10 without keys ( nothing dodgy ) I have a used lockset including ECU ect in the post. Is there a way of getting the seat lock off without destroying It? I do know a locksmith and will be...

Hello Chaps I'm new on here as I'm about to get a 2013 S10 in white with only 3K miles , boxes, carbon bits and an Akra can. Needs a few bits sorting as it has been sitting a while , looking forward to it :)

Hello Chaps I'm new on here and about to get my first Super Tenere . Apart form a few minor jobs it will need a new pair of tyres as its still fitted with the worn original 2013. I like the old Metzeler Tourance tyres on my 1150GS and was going to get a pair for the Tenere. Or do you know...