Search results

  1. S

    No start

    I can't believe this, I had the recall done on my 2012 that was acting up last month (high/low idle) then did a 2,700 mile trip over six days with no issues at all. I just put on a new front tire Saturday and removed the non operating power outlet on the dash as I'm planning on replacing it...
  2. S

    Mounting GPS on Madstad Bracket?

    Hello, has anyone had any issues with mounting their GPS on a madstad bracket? I have a medium Vstream shield with a MRA sport deflector mounted to the top and it kind of bounce around a little in the wind. I was wondering if mounting a Garmin 550 would add too much weight to what seems like...
  3. S

    Yamaha Parts Availability

    My final drive blew a pinion seal two months ago. The drive shaft seal was on two weeks back order. After two delays, the company I ordered from told me the end of September. Bike has been down over two months due to a $15 seal and I'm going to miss my annual fall trip. I didn't have this...
  4. S

    Clutch engagement

    My clutch doesn’t engage until the very end of the travel. Also, my downshifts are notchy . Time for a clutch kit? Bike has 44,000 miles. Clutch just bled and shifter pivot greased and fresh oil and filter. Sent from my iPhone using Tapatalk
  5. S

    Gen 1 turn signal stalks

    Hello, I need front turn signal stalks for my Gen 1. K&S has these for an R1 but doesn't list the Tenere. Anyone try them?
  6. S

    No start after sitting over a year

    Hello everyone, I rescued a 2012 that had been sitting outside for about two years. Of course the seller said it ran when parked. He had put in a new battery and I was able to turn it over and it sounded like it was trying to fire but turned slowly. I brought it home, drained the old smelly...
  7. S

    Clutch won't bleed fluid

    Hello, recently purchased a used and abused 2012 Tenere and was bleeding all the lines when I got the clutch and pull the lever and no fluid comes out. No big deal, I removed the bleeder screw and cleared it out. Still no fluid, so I remove the bleeder screw entirely and pull the lever and...
  8. S

    Seat Removal Broken Lock

    Hello, I just purchased a 2012 last weekend that has seen lots of weather (college student). The ignition key does not fit in the seat lock but the ignition and gas cap work just fine with the same key. Now I'm trying to get the seat off for maintenance. If I remove the security screws that...
Top