Search results

Added a dash with (left to right): waterproof PIAA Driving Lights switch, panel cutoff switch, 12v cigarette, dual USB with 2.1 amps for each, volt meter, OEM 12v cigarette adapter. Added trim to protect wires and cables from vibrational wear. Photo below.

The Rumbux Crash Bars will not allow the PIAA ST adapter for the PIAA lights to fit normally. I had to fabricate an extension bracket. See photos. I first created a template and then used ⅛ inch plate steel and a grinder to shape the bracket. I then drilled the holes and spray painted it with...

I want to wire an iPhone power cord to my PDM60. I bought a USB/iphone cord and when I opened the wire it has three wires not just a hot and ground. I am not an electrician. Photos attached. One brown, one white, and a wrapped white one in the middle. Which wire is the positive and which is the...

I installed the PDM60 and used the DC adapter (recommendation from Yamaha mechanic), the problem is the DC line is always hot and not a good trigger location. Any recommendations for a good trigger wire to tap at the front of the bike? I mounted the PDM60 under the upper right side panel so I...

Hello All, this is my first post here. I am about to buy at Super Tenere ES and have a choice between a new 2017 or new 2016. Cost aside what are the differences between the two other than colour choices? I have been told "minimal" but no details. I thought there might be a previous post but...