Recent content by mww

Update: I found my mistake. I plugged the #4 coil plug into the servo motor they are the same plug. Bike runs fine and no more cam chain rattle on start up. Lesson learned never work tired and fatigued on your bike. and always trust the manual.

Thanks for the reply. I to questioned that ohm reading and used to different fluke meters. I did reverse polarity on the servo motor with my 3 volt test batteries and they open then close with the spring tension and when polarity is reversed they close slightly. Tomorrow with fresh eyes I'll...

Hi new member but long time reader of this forum and just registered for help on my stock 2012 S10 with 27,000 miles I'm getting a code 60 and no start condition cranks but wont run. This happened after changing out the CCT for the updated unit. I did not start the bike prior but it ran well...