Recent content by Muppetlab

so ive narrowed it down to code 63 on the abs side. Tried to cycle the pump today and got it to do it once in about 50 tries. abs pump is constantly clicking. checked out the power to the unit and pulled the abs plug all seem okay. will try bleeding the brakes again but i fear it toast. maybe...

Okay so out to test this morning. Jumped abs and think the abs flashing light is giving out just code 63 or 33. This seems to Indicate either an issue with no power to abs unit, so will recheck fuses and have ago at the abs pump multiplug or front brake mastercylinder pressure awitch which...

Thanks. Do you know of the abs reset procedure of engine kill off and then pressing starter ten times within 4 seconds to wipe codes??

no worries thanks i'll check out fault 42 tomorrow, i know the neutral switch is okay as i could work that one out but will check the clutch switch out.

Thanks very much thats amazing. I thought if the rear sensor was no good the speedo wouldnt work is this correct?

Forgive me for my ignorance but ive trawled the forum and whilst i have some useful info some of it is causing me some confusion. Firstly my abs light has been intermittent after a brake hose and what looked like a long over due fluid change. When bleeding the brakes back up i cycled the abs...

Cheers

Ive been an S10 owner for 9 months and have found this forum fantastic for info relating to maintaining the bike. Hope i can contribute bow also. Thanks Jez