Recent content by lotecredneck

Hey guys, be aware of scammers. I got an email this morning wanting to know if I was still looking for a Sargent seat. He said a guy had one and provided an email. I emailed the guy, but he said he couldn't get pictures to email properly etc... I went to the PM and looked at the guy that sent it...

If you need to change a bulb it surely will. The one he has will have to be removed to change a bulb. Not sure who made the one I have, but I can actually access the back of the headlights with it on. ~Tony

Mine was raw aluminum and I sprayed it with Plastidip. Three coats will do it and you can always peel it off if you want to change it up. I drilled all of my holes then sprayed it. ~Tony

Did you measure them from the top to the ground on each to determine thay were the same height? I have a 2nd gen and they are definitely lower by about 15mm. That doesn't seem like much, but it is quite noticeable. Also, I have mine on with the 8mm pins and they are fine, but you can get 10mm...

Depends upon which filler plate you have. Mine is a flat piece that I drilled a hole on either side then drilled a hole in the upper fairing area and placed a wellnut like is used in the windshield mount and it worked perfect.

I'm open to reasonable offers.... ~Tony

I found it used, so I wouldn’t have any idea on wait times. ~Tony

It is definitely much better than the stock seat. It's wider at the back and the foam is more firm than the original. ~Tony

Here's a photo from the back of the seat so you can see how low it actually is...

Yes, I don't think they could make a lower seat than this one... This is approx 1 1/2" lower in the seating area than the OEM seat. ~Tony

I bought a couple of seats and decided to keep the Laam seat and sell this one. This seat is the low version on a Seat Concepts pan so you won't have to have the cover and foam installed on your factory pan. This is simply a plug and play seat. It has a few scuffs from boot drag, but not bad at...

It does make a difference. I have mine all the way down and one step forward in the picture. ~Tony

I was looking for some adjustable pegs for my T12 to lower them a touch to take the strain out of old knees. I ran across the SW Motech Evo pegs, but wasn't thrilled with the $209 price tag. As I was going through the website, they had a sale on some that according to their website wouldn't fit...

It is most likely for a Ram Ball to mount....

Looking for a better seat for the S10. If you have one collecting dust, let me know..... ~Tony