Recent content by hodee

You tube is your friend !!! Got the shock out through the top rather than from the bottom. Still, yamaha should have installed the bolt from the other direction !

Rear shock removal on a Gen 1 2012. Everything was going easy until the last bolt ! why didnt the stupid designers or installers put the bolt in from the other direction !!!! Anybody ever push the bolt as far as it would go. then cut it off. Upon reinstall , get a new bolt and insert the logical...

i may be mistaken but, code deletion is different from Gen 1 to Gen 2. Unaware of what to check with neutral and clutch switch. Neutral light functions well, but I'll give some attention to the clutch switch for sticking or abnormalities. thanks

i finally replaced the rear wheel sensor and now need to delete the codes. I have held both buttons (GEN 1) while turning on the key. DIAG mode shows on the dash but no codes appear. How do I get the codes to appear and how to delete? Thanks

I dont have cruise control on my Gen 1, so im curious what other causes might be at fault. thanks.

I have no speedometer or odometer and error code 42. I replaced the rear speed sensor but have not deleted the code yet. Anybody else lose their speedo/odo?

I would be interested in the Wyo BDR next year ! Super Tens Unite !

is there a diagram showing the order of steering head bearings,nuts etc? I read mention of a lock washer going under the top triple clamp, but mine does not have one. Curious.

Unfortunately, I can’t find info on deleting codes for gen 1.

I know the gen 2 bikes have a reset button on the left side of the dash. The Gen 1 bikes have two buttons on the lower right side of the dash. But.. I can not find any info on how to delete fault codes for the Gen 1. Specifically 42 and 69 which are whee

I disagree that when coming down a loose hill a properly modulated front brake is essential. The front already does 70% of the braking on flat land, even more so going downhill. It is critical to use the front brake, but with caution. Only using the rear leads to a LOT of skidding around.

Been there done that exact pass. Fully loaded. Quite a pucker factor !!! Came down Engineer Alpine Loop Road into Ouray. It was even worse!!!

I’m thinking on the lower right side of the dash for Gen 1 but I can’t wait to give it a try deleting codes. Thanks all day for your help. I can’t believe how clueless the dealers can be...

The code deletion methods I’ve seen posted are for the 2014 and up Gen2 bikes. They use the reset button but I don’t know if there is one on gen 1.

Thanks again Eric, lots of help. But I don’t see the link to do my own fault deletions. Cheers