I combined this light bar from Rigid Industries (90669):
http://www.rigidindustries.com/led-lighting/90669
with these spot beams from Cyclops:
http://www.cyclopsadventuresports.com/-Long-Range-Optimus-LED-Auxliary-light-Round_p_10.html
The rigid industries default brackets mounted...
List of Ethanol free gas stations in the US and Canada.
http://pure-gas.org/
Lately I've made an effort to buy gas from these sellers. If I venture inside to buy a snack I make sure to have the employee mention to the manager that I only purchased fuel at their store because they sell Ethanol...
I'm 6' 5" and have no issues with leg room. I did a 500 mile ride over the weekend to break the bike in and test out gear. I have the seat in the "high" position. I installed the taller Yamaha OEM windscreen. It seems to reduce buffeting the top of my helmet was experiencing. I removed the...
Honestly, I would go see a dermatologist and get checked out. It could be something as simple as allergic rhinitis caused by an outdoor allergen or even hyperdynamic circulation caused by the vibration.
http://www.aad.org/find-a-derm
I can't comment on the two devices you are asking about as I have never held either one. However I can comment on the networks each utilizes. Spot uses the Globalstar network. Delorme uses the Iridium network (technically they are satellite constellations). I have a lot of experience using voice...
@TNWalker/Steve,
You went above and beyond on that post. Thanks a ton for your help. The photos were great. I'm sure your post will help others as well as myself.
1. Do the instructions include directions on how to wire it so it is connected to the OEM turn signal switch? (I wouldn't have the first clue how to do it).
2. I assume you had to drill holes in the panniers to connect to the light bar. How big is the hole? How did you seal it up?
2. Are you...
Ahh. Now I understand. Thanks for the clarification. If you want to post the photos it might help someone else who comes along. I'm good with your explanation. Thanks so much for your help.
I searched quite a bit but can't seem to find the answer anywhere (I even search the Yamaha parts catalog). What is the diameter (OD) of the Super Tenere OEM crash bar? (Thanks in advance).
Thanks for the reply. If I understand correctly, use the brackets shipped with this unit and sort of manhandle it into place using the the two lower forward facing bolt holes?