Recent content by 4n6guy

Thanks Dogdaze. I was looking in the wrong places. This should do it for me!

I don't have the service manual yet and don't have a wiring diagram either. I am installing the Denali PowerHub2 near the relays and wiring harnesses and am looking for a switched 12V power source to connect to yellow wire from the the PowerHub using a "Posi-Tap” connector. I guess I could...

I agree and will be investing in the service manual!

I realize that it has been a long time since anybody has posted to this thread and that the topic has been thoroughly discussed, but I have to say thanks to the inmates with mechanical know-how and experience for posting these tips! I'm not all that mechanically inclined, but learning and...

Hey RockyDS, I'm heading up the same way. Maybe we'll cross paths? http://www.yamahasupertenere.com/index.php?topic=15074.msg234758#msg234758

Hello rengler from Terrace, BC. Congrats on your new "steed". Enjoy!

I am planning to make the trip from Terrace, BC to Inuvik, NT with a "stopover" in Dawson City YT for the Dust 2 Dawson ride (don't call it a rally) which is scheduled for June 18 to 21, 2015. For more info on the D2D, see: http://dawsoncity.ca/event/dust-2-da...le-ride-rally/ I am planning on...

On a one-week from Northwest BC, through the Rockies and Kootenays, to the Okanagan and back. Camping gear (including tent, pad, cooking gear, food), plus riding gear and clothes.

I pulled the bike out of the garage to start it up after the install to test the heaters. It was around -10C. I ran the bike for about 10 minutes and the grips were nice and warm. I didn't notice any appreciable temperature difference between the two, and because of all the discussion in this...

Toward the end of August, I hope?

OEM heated grips installed today. It took longer than expected but I hadn't considered the time to remove the LHS Altrider crash bar to get the side panel off ...just to get the fuel tank undone :mad:! Wish I had read through the entire (15 pages) thread before starting because as someone else...

Thanks for the advice, HoebSTer! Always willing to learn from others' experiences. As for uploading the instructions to this site, the PDF files are too large. I've sent them by e-mail.

Hey, Towboatcrisco! I'm still waiting for my garage to warm up a bit so I can install my heated grips! I can only dream of riding for now...we have to wait a little longer up here than you do in the LMD :(!! I plan on taking a trip through the Kootenays and the Duffey Lake loop in June. No...

I scanned the "Grip Heater XT1200Z Mounting Instructions" to PDF but the file size was too big to post. Tried reducing resolution but once file size was small enough, the diagrams weren't readable. Will work on a better solution. Any suggestions?

I just got the OEM grips and have the instructions. Have been checking this thread for tips 'n tricks for install 'cause the instructions consist of an exploded parts diagram...I would have preferred a few written instructions, but will make do with what's there. There are 7 pages of...