You punch a hole, it is not drilled. The metal peals back with no debris. I used an old sharpened Phillips screw driver to start it and a center punch to finish it. I did put a rag in the filler neck and blew it out when finished. The rag also keeps the gas from splashing when hitting the punch.A dumb question. How do you punch holes in the filler neck without getting metal crud in the tank?
All that to say I'm not really sure. But definitely a good effort:benefit ratio.I like the idea of the two holes in the upper side when on the kickstand, but how much does that really add?
Two good points. I only superfill as I exit for a ride that's at least 15 miles. That is, I don't superfill then go inside and shop, eat, etc.My opinion not much advantage with the extra holes because if you fill it that full gas will start coming out the overflow hose and dripping on the ground. If your really worried about running out of gas probably a better idea to just carry some extra gas in another container.
It isn't so much getting more in, it's your ability to do it more quickly. I tended to run out a patience waiting for the pressure to equalize and the fuel to drop in the neck. Some pumps are worse trickling fuel to top it off, so the holes make it more accommodating for a quicker pump. As stated by others, you do need to be careful about over filling unless you are riding off. I did put two of the holes on the right side and 1 at ~10:00. I will use either stand when fueling.How much extra fuel goes in with the holes in the filler neck?
Reason I ask is on my new to me '23 I hit the fuel flashing light and estimated mileage to empty was dropping faster than expected and when the countdown to empty started I was nursing it to the gas station where I put in 5 gallons. So I might have had some extra or might not, don't know how much was really left.
I like the idea of the two holes in the upper side when on the kickstand, but how much does that really add?
I was not, but that said, DO THIS AT YOUR OWN RISK!Late to the party, but aren’t you guys concerned about making a spark when punching a hole?
maybe it’s brass, or something similar; I hope so
Wouldn’t be s good time to experience static electricityI was not, but that said, DO THIS AT YOUR OWN RISK!
With the right tools and technique there is constant contact. The tank metal is relatively soft and it is fairly slow as the punch enlarges the hole. I suppose Jay Leno would lubricate the punch with gasoline first...