BuellOnYamaha
New Member
- Joined
- May 10, 2020
- Messages
- 18
HI:
Couldn't find a thread that addressed this issue. I just changed my rear tire and reinstalled the wheel, then torqued the axel nut to 90 lb/ft, with the pinch bolt loose and a 19 mm hex tool to counter the torque wrench.
I'm left with about a 1/4 inch gap between the right swing arm and the brake caliper. I hoped when I torqued the axel nut it would pull the swing arms together and snug up. Not so.
Any idea where I went wrong and how to correct?
Couldn't find a thread that addressed this issue. I just changed my rear tire and reinstalled the wheel, then torqued the axel nut to 90 lb/ft, with the pinch bolt loose and a 19 mm hex tool to counter the torque wrench.
I'm left with about a 1/4 inch gap between the right swing arm and the brake caliper. I hoped when I torqued the axel nut it would pull the swing arms together and snug up. Not so.
Any idea where I went wrong and how to correct?
Attachments
-
204.9 KB Views: 165