FALCONSEYE
Member
Sorry in advance. I have a 2012 which was purchased in 2013 Yamaha Super Tenere. I purchased a set of Givi PL2119 CAM for outback side case mounts. This piece of sh1t won't fit.
When I align the top 2 screws, see how the bottom part by the foot peg is way off? the screws are very loose, but I cannot seem to pull it back enough to make that foot peg piece work. If align it by the passenger foot peg, then the back screw becomes way off. Also, the screw for the passenger foot peg is not long enough.
What is this crap marked as 10 in diagram A. The first diagram that shows each part number ends at 9, not 10.
Did I purchase the wrong part? Please see attached photos.
Here is the installation instructions : https://www.revzilla.com/assets/0001/1935/givi_pl2119_cam_side_case_racks_super_tenere_xt1200_z20142015.pdf . Page 2 shows each piece.
When I align the top 2 screws, see how the bottom part by the foot peg is way off? the screws are very loose, but I cannot seem to pull it back enough to make that foot peg piece work. If align it by the passenger foot peg, then the back screw becomes way off. Also, the screw for the passenger foot peg is not long enough.
What is this crap marked as 10 in diagram A. The first diagram that shows each part number ends at 9, not 10.
Did I purchase the wrong part? Please see attached photos.
Here is the installation instructions : https://www.revzilla.com/assets/0001/1935/givi_pl2119_cam_side_case_racks_super_tenere_xt1200_z20142015.pdf . Page 2 shows each piece.
Attachments
-
1.1 MB Views: 78
-
3.1 MB Views: 75
-
2.7 MB Views: 77
-
3.3 MB Views: 75
-
3.7 MB Views: 71
-
4.3 MB Views: 66
-
1.1 MB Views: 64
-
1.4 MB Views: 66
-
1.1 MB Views: 58
-
1.4 MB Views: 50