DutyFirst
New Member
I am currently fitting spot lights to my 2015 S10 and wanting advise on where is the best/most accessible place to connect to my ‘High Beam‘ wire?
Spot Light Connection.
- Thread starter DutyFirst
- Start date
cyclemike4
Well-Known Member
I tapped into the high beam wiring on the upper right side of the bike. I had to take the side panel off and then the colored plastic above it. I have a 2012 so I am not sure if it would be the same but should be in the same location. Sorry I can't remember the color wire that you need to look for. I did this years ago and just don't remember off hand.
Fennellg
Well-Known Member
Most run off the aux plug.
Fennellg
Well-Known Member
This should help. If you get an eastern beaver fuse block it’s plug and play. gives you switched and un switched fused circuits. I took the more difficult route. Made a custom plug for my lights. It was fine. There wires one hot un switched one switched hot and a ground. One shot deal. No room for expansion . Well wanted my GPS hot all the time and my electric heated gear switched so my battery won’t get nailed by accident. Went back and installed a eastern beaver pc8. It plugs in the aux port. Install a snap. And future installs also a snap.