prowlnS10
2014 ES
Dimension are similar to Altrider's Dual Control unit except height of elevated section for standing is approx 1/8" less because Pivot Pegz are mounted in low position & brake lever is adjusted to the lowest position.
Upper section 5/8" long x 7/8" high (front cleat), lower section 1.25" long x 3/16" high (front cleat), total length 2.0" (front cleat is 1/8"" higher than back for better contact because of foot angle), offset mounting so that left side overlaps oem brake cleat 1/4" to minimize protrusion to right to allow for increased foot room....fits comfortable for my size 12 foot.
Used triangle file for cleats , grooved channel on bottom with Dremel tool to fit cleats of oem platform for stability, clear coat.
Made from 1.25" u-channel or box aluminum 1/8" stock, right angle steel corner bracket, 2 (35 & 20 x 8mm) button head bolts/nyloc nut.
Upper section 5/8" long x 7/8" high (front cleat), lower section 1.25" long x 3/16" high (front cleat), total length 2.0" (front cleat is 1/8"" higher than back for better contact because of foot angle), offset mounting so that left side overlaps oem brake cleat 1/4" to minimize protrusion to right to allow for increased foot room....fits comfortable for my size 12 foot.
Used triangle file for cleats , grooved channel on bottom with Dremel tool to fit cleats of oem platform for stability, clear coat.
Made from 1.25" u-channel or box aluminum 1/8" stock, right angle steel corner bracket, 2 (35 & 20 x 8mm) button head bolts/nyloc nut.
Last edited: