Scubatech
Member
Here's my issue. I was installing a new battery last week. I had the battery cables pushed under the wiring loom above the battery. As luck would have it as I pushed the battery into the box the positive cable dropped and briefly touched the negative battery post! So I had no power and started checking all the fuses and relays that the owners manual shows. I found & replaced the main 50 amp fuse. I now have fuel pump operation and an engine that spins normally but the Bike will not start! I've tried the cold start procedure and no start.
Tobasco has been kind enough to help me figure this out but so far we have no answer. I thought with the main fuse blowing the current would stop there and everything else would be OK.
I'm sure I will have to get a trailer and take my Bike to a Dealer but maybe someone has seen this before?
Tobasco has been kind enough to help me figure this out but so far we have no answer. I thought with the main fuse blowing the current would stop there and everything else would be OK.
I'm sure I will have to get a trailer and take my Bike to a Dealer but maybe someone has seen this before?