Bigguy136
Well-Known Member
Just thought I would add a few photos of a new mount I made. I didn't see what I wanted so next thing is just make what you want. I want to use the quick disconnect on the GoPro rather than loosening/ removing/ dropping the threaded knob.
Simple .125" AL lasered and formed. Then a mount from PTFE with 6MM helicoils. I have it sized so I can add vibration dampeners but all good so far without. Also mostly engine noise and little wind noise.
Now to figure out what settings to record in. I have a GoPro 8 if anyone has a good starting point??
Simple .125" AL lasered and formed. Then a mount from PTFE with 6MM helicoils. I have it sized so I can add vibration dampeners but all good so far without. Also mostly engine noise and little wind noise.
Now to figure out what settings to record in. I have a GoPro 8 if anyone has a good starting point??