shift_enter
Active Member
2013 scooter. i got some denali LED marker lights which can run on 50% power or 100% power.
I plugged them into the aux light connector under the right fairing and they powered on even though the bike was off.... after doing some research I see that one of the wires in that connector is always on... [thumbs down] So I am gonna cut that wire and let the ignition controlled wire and ground wire from that connection run my lights. I would like to have them blink with the indicators though.... tapping into the turn signals to use the 100% power capability and have them run on 50% all other times, but I don't wanna mess anything up. do you think tapping into a turn signal will send an error code? they're LEDs so the draw is low.
From what i could decipher from the wiring diagram, I think i need to find the 12 wire connector and get the dark green and chocolate wires for the turn signals. yeah?
I plugged them into the aux light connector under the right fairing and they powered on even though the bike was off.... after doing some research I see that one of the wires in that connector is always on... [thumbs down] So I am gonna cut that wire and let the ignition controlled wire and ground wire from that connection run my lights. I would like to have them blink with the indicators though.... tapping into the turn signals to use the 100% power capability and have them run on 50% all other times, but I don't wanna mess anything up. do you think tapping into a turn signal will send an error code? they're LEDs so the draw is low.
From what i could decipher from the wiring diagram, I think i need to find the 12 wire connector and get the dark green and chocolate wires for the turn signals. yeah?