stuarto49
Member
Working on my 2012 Super Tenere with about 30,000 miles. A few months ago did the clutch and brake fluids and used my jumper cable (originally from my FJR) to cycle the ABS system during the brake bleed. No issues until recently when ABS light came on steady a few times. Was able to clear off the light by shutting down and restarting the engine. Now it will return and stay on steady all the time.
Went into DIAG mode to look for any error codes but not sure I am following correct procedure. Kill switch OFF, holding down both buttons while turning on ignition,, 8 sec, displays DIAG. Then I hold down both buttons again and will display as I scroll: d:01 -> 14, d:03 -> 101, d:05 -> 68, d:07 -> 0, d:08 -> 11, and so on. So I've printed much of the manual, especially the ABS section. Just not sure I know what I am looking at with these codes. I don't want to clear any codes prematurely.
I have cleaned both wheel sensors, next is to trace cables and check connections from each of the sensors.
Stuart, Richmond, VA
Went into DIAG mode to look for any error codes but not sure I am following correct procedure. Kill switch OFF, holding down both buttons while turning on ignition,, 8 sec, displays DIAG. Then I hold down both buttons again and will display as I scroll: d:01 -> 14, d:03 -> 101, d:05 -> 68, d:07 -> 0, d:08 -> 11, and so on. So I've printed much of the manual, especially the ABS section. Just not sure I know what I am looking at with these codes. I don't want to clear any codes prematurely.
I have cleaned both wheel sensors, next is to trace cables and check connections from each of the sensors.
Stuart, Richmond, VA
