auto tune o2 sensor bung

[Xclimation]

I've searched and read many posts/threads couldn't find the answer:

I have a 2015 Gen 2 . I have stock headers with the catalytic converter removed. Looking at my headers a good location for an auto tune o2 sensor bung would be on the spot where the catalytic converter used to be. Would this be a good location to weld a bung for the auto tune o2 sensor?

I read posts where some said the best location would be so many inches from the catalytic converter....but I cut mine out.

Thank You in advance!

 

[Fatallybitten]

That is where mine was welded on my 2014 ES with Arrow headers.

 

[~TABASCO~]

Just install it after the two pipes come together. That's it.

 

[Xclimation]

Just install it after the two pipes come together. That's it.

On the stock pipes the pipes come together right at where the catalytic converter was before I cut it out. I actually looked at your post on where you weld them on the Arrow headers.

 

[doc187]

I followed tobacco's post as far as bung location and it's up and out of the way and doesn't rub on anything. Recommend putting your there.