Mikeybikey57
Member
After much deliberating and head scratching as to whether I should go a stage further with forking my S10, my mind was made up for me after I bagged a very clean set of Arrow headers for my S10, through flea-bay (see photo).
I'm not planning to fit them just yet but I do need some advice, as I've never actually fitted an exhaust system that is essentially, held together with springs.
So, this is for folk who have the same headers on their S10's: Will I need to use some kind of gasket cement or hi temp silicone on the joints that are held together by the springs, or is the fit tight enough to not need any?
I'm not planning to fit them just yet but I do need some advice, as I've never actually fitted an exhaust system that is essentially, held together with springs.
So, this is for folk who have the same headers on their S10's: Will I need to use some kind of gasket cement or hi temp silicone on the joints that are held together by the springs, or is the fit tight enough to not need any?
Attachments
-
35.7 KB Views: 44