Search results

  1. Al-n2it

    Hauling A Super Tenere in a Truck

    5 Hours home using 4 straps in my F150.
  2. Al-n2it

    Heated grips.

    I don't think that relay has anything to do with the factory grips. The service manual doesn't show a relay in the system. I would test the resistance of each grip at the connectors. Values you should see are below.
  3. Al-n2it

    OEM side box hardware? Where to buy?

    I wrote the OEM part numbers off the bolt bags down before I started the installation. might help... https://drive.google.com/file/d/0B45AHgZY4FwTNlU1aHRQaGVWR1k/view?usp=sharing
  4. Al-n2it

    Crossbar behind the wind screen and gps

    This has been rock solid, even off road with my old heavy GPS. https://www.yamahasupertenere.com/index.php?threads/gps-mounting-options.21010/post-301233
  5. Al-n2it

    Factory Service Manual on CD

    Just a suggestion...have you googled LIT-11616-27-59, returns some useful results.
  6. Al-n2it

    Brand new Givi skid plate.

    If it’s still available, I’ll take it. Sent from my iPad using Tapatalk
  7. Al-n2it

    What is this for?

    My guess... it is so the passenger's foot won't kick the rubber cap off when the bag is not installed. It is only on the LT side because the RT bracket is tucked inboard more and the passenger's foot is less likely to hit it. Next puzzle please. Sent from my iPhone using Tapatalk
  8. Al-n2it

    where did you TAKE your Tenere today?

    Top Of The World Hwy into Alaska! Sent from my iPhone using Tapatalk
  9. Al-n2it

    where did you TAKE your Tenere today?

    Day 5 of our month long AK run. 1980 miles in we reached mile 0! Sent from my iPhone using Tapatalk
  10. Al-n2it

    What you did to your Tenere today??!!

    Loaded it. Leaving for Alaska today. Sent from my iPhone using Tapatalk
  11. Al-n2it

    Alaska Trip Preparation

    Do I need to put my tent in a dry bag for my upcoming trip to AK. I have dry bags for sleeping bag and clothes, but do i need one for the tent? The thing is going to be getting wet as soon as I take it out of the bag, is there something i haven't thought of? Allen
  12. Al-n2it

    Shop Manual & Assembly Guide

    Re: Shop Manual & Assembly Guide Risers? Tell me more! I've been staking these on eBay. Are yours similar...
  13. Al-n2it

    What you did to your Tenere today??!!

    Just 3M tape, the automotive type, I use the stuff at work for mounting everything. The key is to clean the surfaces and heat them up just a bit.
  14. Al-n2it

    What you did to your Tenere today??!!

    Made these from a sheet of 1/8" Kydex. Created the pattern using a Manila file folder, its reversible for LT and RT. Heated with a heat gun and formed, then immediately cooled with a rag soaked in icewater. Huge improvement in cold weather.
  15. Al-n2it

    What you did to your Tenere today??!!

    In preparation for my May 20th trip to Alaska, I have been getting the bike dialed in. Mounted my Tourmaster Synergy controller to the bottom of the left switch pod and hard wired it to a Firstgear coax port. Made a mount for my $9 Kmart gas jug using some aluminum scraps and poor welding...
  16. Al-n2it

    Heated grips.

    Re: 2014 Non ES Factory Heated Grips I upgraded to the OEM heated grips on my 2014 today. Purchased the four needed parts from http://www.georgiawatersports.com for $237 shipped to CA. Thanks to Tupperware for sharing his copy of the Factory instructions. I wanted to add an additional photo...
  17. Al-n2it

    2014+ Aux Plugs/Electrics vs Other Models

    I just starting reading this topic so please excuse me if the four pin info below has been covered. I am researching the 3 pin connector to be used to power my elect vest (draws 5 amps) off the switched wire and power my GPS and a USB port off the alway hot wire. I like to work on my GPS...
  18. Al-n2it

    GPS Mounting Options

    Made this from a small plate of aluminum and these clamps from Amazon. https://www.amazon.com/Billet-Specialties-65510-Line-Clamp/dp/B002RUYRUU Had to file a little bit off the two mating surfaces so it would clamp tight enough but after that it's good, hasn't moved at all. i got the clamp...
  19. Al-n2it

    Anyone use helmet sunblocker?

    +1 elect tape!
  20. Al-n2it

    Member/Software Developer Seeks Relocation to SoCal

    Did you try this little company? https://www.amazon.jobs/en/locations/san-luis-obispo-california?base_query=&loc_query=&job_count=10&result_limit=10&sort=relevant&location%5B%5D=san-luis-obispo-california&cache
Top