Search results

Yea dam ethanol

Pretty easy to do yourself

I was lucky and it didn’t wreck the motor. Just re alignment and new cct

Rough low RPM slight popping No longer daily rider. Switched careers to OTR truck driver. Started right up when I got home. Was in heavy traffic fan running allot. shut down 3 hours then noticed low power a little popping below 2500 rpm.seemed to idle ok just on starting out, slow traffic...

My outer side brake side rear disintegrated at 100 k mi. Good to replace at 80k I bet. My dealer said run till the go bust

Thanks the power sports place is closed I’ll try Napa thank so much I’m visiting my daughter on my way to the Dakotas. My still angry X wife comes in tomorrow

Internet faster in the morning up here. The outer race fell apart as I wss trying to knock it out. I’ll need help to get the inner on hub out

Rear not front thanks though

Stuck in Mammoth lakes. Biggest town, Reno 2 hours away. Bishop is a half hour with a small shop Does anyone know any options for different bearing that will fit just to get back to San Diego? Outer bearing at disc break disinigrated Thanks

Rear wheel bearings substitute ? Stuck in MammothLakes. Bishop is the closest then Reno. Thanks!!

:D Traffic never a issue in CA. We lane split. 8)

Yamaha highly recommends using cleaner. Really! ?? What do you use? I figured the carbon eventually kind of flakes off and goes through the exhaust. It was thick (1/16") inside my motor. I ride hard and fast but rarely over 5k rpm. 5k in 6th is near 100 mph. I've always used Premium as...

Carbon build up ?? Maybe someone could chime in? Pistons were replaced but I scrubbed the heads with gas, tooth brush and soft wire brush leaving residue. Carbon was thick on both head and pistons. IS IT FROM RUNNING PREMIUM GAS ?? I'm betting. I also bet you could run regular in this bike...

She’s the cleanest since delivery. Every nook and crany cleaned treated with tri flow. Special thanks to steve68steve and TOBASCO Back to hammer down

She Lives !!!!!! Yamaha Super Tenere Forum helps save a S10 from the scrap HEAP :o My '12 S10 Came back to life today after almost 2 months down. She sounds and runs great. No more noise for a few seconds on cold start.....LOL The Scoop; Chain slap on cold start. Dealer mentioned when I...

Never found the other "half" ::) Maybe I'll drop the pan and have a look. Now that I'm a ACE S10 mechanic . 8) ::) :D ::012::

She Lives !!!!!! Came back to life today. She sounds and runs great. No more noise for a few seconds on cold start.....LOL The Specs Chain slap on cold start. Dealer mentioned when I was in for a valve adj. Both dealer and myself unaware of "known," .... CCT "issues."...

Howdy I’m on the final stretch of a top end rebuild w new pistons. I am having trouble identifying where 3 things get connected to. Any ideas? Gracias

After bending one oil ring trying to feed cylinders back over pistons, over a month of waiting for parts, the motor is back in the bike. ::018:: I had to install 2 new pistons due to bending the ring. Had a bud help me assemble. The cylinders / pistons ect.and feeding the rings back in...

I was headed up The Haul Road, AK and met another overlander out on the Steese Hwy near Circle. I was planning on making the run up to Prudo. This guy told me about the Dempster outside of Dawson (after Chicken and Top of the World). I was super glad I took his advise to skip The Haul Road...