Search results

  1. Jlq1969

    Adjusting ES suspension ???

    The preload is only in the rear spring….the rebound and the sinkingis,… forward and back together
  2. Jlq1969

    How to use traction control

    It is that you have the answer, in your question…..”when you are stuck in the mud”…..stuck…it is too late to think about the TCS On or Off….if you anticipate what is in front of you (deep or not, mud)….you have to decide before what to do…TCS On or Off…..if you don't want to go through the mud...
  3. Jlq1969

    Speedometer WAAAAAAY off

    I took this data from another publication... but it seems that the ECU was distributed in this way in 2012/13... what is the difference in -00/-30/-40... etc... I don't know, or why it appears for the same model/region, 2 ECUs?…..but in some publication I knew how to read that in France the...
  4. Jlq1969

    The anything thread.

    With -22….if it were a Tesla, the empty distance would go from 215 miles to …2 miles…in a couple of seconds:)
  5. Jlq1969

    The anything thread.

    It seems that there is another one that bought it online:):)
  6. Jlq1969

    Tracer 9 GT+

    Although it doesn't show it, the audio clarifies that the chassis is split on both sides... and without crashes... that's why it's for scrapping. It probably may have been a low blow in the engine
  7. Jlq1969

    Tracer 9 GT+

    I don't know what to comment… could it be a crash?…..but he says it has no crash https://vm.tiktok.com/ZMYFDvuoW/
  8. Jlq1969

    ECU self flash? Off to a rough start

    4 pins under the seat, is for ABS diagnosis…..the other 4 pins(in right side), is for ECU diagnosis, but I think 2012/2013… don't have an ECU OBD port
  9. Jlq1969

    O2 sensor removal: how did you fill up?

    Removing them in the Software... does not necessarily imply "physical removal"…..just leave them there….
  10. Jlq1969

    You're selling your bike, you're moving on, what NEXT ?

    I think this does nothing more than position the 1290 as the Queen of current Maxitrails….
  11. Jlq1969

    You're selling your bike, you're moving on, what NEXT ?

    https://www.rideapart.com/news/633453/bmw-r1250gs-gearbox-shaft-recall/
  12. Jlq1969

    Cleaning anodized wheels?

    I clean everything with “window cleaning liquid”…..everything….but, the liquid has to be the best. There are many on the market, but only the good ones will work fine. And when I say everything, it is everything… Engine, tires, seats, dashboard, synthetic leather seats, glass, kitchen counter...
  13. Jlq1969

    Volume in liters

    I think that in case/suitcases and bags, the cubic capacity that can be contained inside is not measured, the measurement in liters refers to the cubic capacity of "space" that it occupies (that is why it is measured as a perfect cube or rectangle)... To cube something that is not a perfect...
  14. Jlq1969

    Problem with ABS, the abs motor fuse burn out each time

    Another check that you can do is to replace the fuse with a lamp, of several watts (55w)….if when you cycle the abs, the lamp comes on….it is a sign that the engine, when it tries to drive, goes to ground… ..If the lamp does not come on, it could be a sign that the motor is only stuck, but not...
  15. Jlq1969

    Problem with ABS, the abs motor fuse burn out each time

    That would not be good news… but I don't remember reading anything about it. It would be necessary to check the abs motor “relay”.….
  16. Jlq1969

    Problem with ABS, the abs motor fuse burn out each time

    That in principle would be good news…..You would have to rule out that the blown fuse is because the abs motor is stuck. You should search the forum for the procedure to cycle the abs pump….To manually run the abs motor……
  17. Jlq1969

    Problem with ABS, the abs motor fuse burn out each time

    test with a multimeter….take out the blown fuse and test if there is continuity with the chassis/terminal(-) of the battery….if there is continuity, it could be a damaged cable (touch the chassis)…or the abs motor burnt….The abs motor “only” works when the abs is activated….or…when you use the...
  18. Jlq1969

    Problem with ABS, the abs motor fuse burn out each time

    Under the driver's seat, there is a four-pin “square” connector, check that it has the cover on and that it does not have water…. Did you buy the motorcycle used??…..I ask because it may have had a homemade abs disconnector, maybe once they took it out and left poorly insulated cables
  19. Jlq1969

    Complete headlight upgrade

    Apparently, there was a time when there were many animals loose on the road, added to the fact that people had some complex that they were being persecuted:) P
  20. Jlq1969

    Problem with ABS, the abs motor fuse burn out each time

    If the fuse burns, it is a sign that something is shorted…..if you say that the problem started “after” washing it with pressurized water…..I would start by checking the abs module plug… You have 2 fuses….one for the abs module and another for the abs electric motor
Top